Explore guide
Work through a mixed-unit pattern
Choose one working unit and preserve the pattern’s intended measurements through conversion.
Related lessons and tools
Choose one working unit and preserve the pattern’s intended measurements through conversion.
Before you start
Gather the measurements, counts or timing sample needed below. Record their units and whether they describe a sample, the whole project or one purchased package. Use a finished sample when dimensions or material use depend on fabric structure.
How to do it
- Work with mixed length units — Convert each length into one working unit before adding or comparing it. Keep the source value and round only the final displayed result.
- Gauge per 10 cm and per four inches — The conventional gauge spans are close but not exactly equal: four inches is 10.16 cm. Keep the stated measuring span when precision affects fit.
- Measure stitch density away from edges — Count complete stitch intervals across a central measured width. Do not include a tight selvedge or stretch the ruler span to obtain a desired result.
Try this example
A converted panel target is 25.4 cm. Preserve that value instead of shortening it to 25 cm, then round stitch counts to the permitted repeat and inspect the resulting width. Converting units does not change the intended physical size.
Check your result
- Recheck the inputs against the actual sample or label, keep units consistent and round only the final count or purchase. Repeat a sample if a small measuring difference changes the decision.
- These arithmetic examples assume the measured structure stays comparable. Shaping, borders, dense textures and color changes require their own allowances or samples.
Sources
Measurement converter
Convert craft lengths and masses between metric and imperial units.
Before you use this tool
Select the unit printed beside the original number, then the desired output unit. Convert length to length or mass to mass.
For yarn, grams cannot become metres without that yarn’s label ratio. More precision changes the displayed digits; it does not make the measured input more accurate.
Method and limits
Formula and assumptions
Length and mass conversions use exact standard factors before the displayed value is rounded. Length cannot be converted directly to mass.
Worked example
Example: 100 centimetres displays as about 39.4 inches at practical precision; the optional detail control shows 39.3701.
Limits and rounding
Results are planning estimates from the values entered. Displayed decimals are rounded for craft use; whole materials and repeats round up where the method says so. Confirm gauge, material behavior, construction, and finished measurements before committing supplies.