# [Measure stitch density away from edges](https://threadcabin.com/explore/108/measure-stitch-density-away-from-edges)

> Count complete stitch intervals across a central measured width. Do not include a tight selvedge or stretch the ruler span to obtain a desired result.

- Canonical page: https://threadcabin.com/explore/108/measure-stitch-density-away-from-edges
- Language: en
- Published: 2026-09-25T17:26:33.1732403+00:00
- Updated: 2026-09-25T17:26:40.3690355+00:00
- Primary image: [Measure stitch density away from edges — example diagram](https://threadcabin.com/images/learning/s26-plan.png)

Count complete stitch intervals across a central measured width. Do not include a tight selvedge or stretch the ruler span to obtain a desired result.

## Before you start

Gather the measurements, counts or timing sample needed below. Record their units and whether they describe a sample, the whole project or one purchased package. Use a finished sample when dimensions or material use depend on fabric structure.

## Try this example

Twenty-two stitches across 10 cm means 2.2 stitches per cm. A 30 cm panel starts near 66 stitches before edges and repeat fitting are considered.

## Check your result

- Recheck the inputs against the actual sample or label, keep units consistent and round only the final count or purchase. Repeat a sample if a small measuring difference changes the decision.
- These arithmetic examples assume the measured structure stays comparable. Shaping, borders, dense textures and color changes require their own allowances or samples.

## Sources

- [www.purlsoho.com: all about gauge](https://www.purlsoho.com/create/all-about-gauge/)
- [www.craftyarncouncil.com: yarn weight system](https://www.craftyarncouncil.com/standards/yarn-weight-system)

[Browse editable craft templates](/crafts)

[Report a correction](/corrections).

## Sources and provenance

- [Gauge is a fabric measurement, not a needle promise](https://threadcabin.com/explore/2/gauge-is-a-fabric-measurement-not-a-needle-promise)
- [Make a representative finished swatch](https://threadcabin.com/explore/107/make-a-representative-finished-swatch)
- [Calculate knitting stitches for a target width](https://threadcabin.com/explore/69/calculate-knitting-stitches-for-a-target-width)
- [Gauge & size planner](https://threadcabin.com/tools/gauge-size-planner)

## [Gauge & size planner](https://threadcabin.com/tools/gauge-size-planner)

Turn a measured swatch into stitch and row counts for your finished size.

Wash and rest a sample in the project’s stitch pattern. Count stitches and rows inside measured central spans, excluding edge distortion.  Positive ease adds room to the target width; negative ease subtracts it. The rounded result is a planning count; fit repeats and construction details before casting on.

Formula: stitches ÷ swatch width × target width after ease; rows ÷ swatch height × target height. Each result follows the selected up, down, or nearest rounding rule and its stitch or row multiple.

- Stitches: 22
- Rows: 30
- Swatch width: 10 cm
- Swatch height: 10 cm
- Target width: 30 cm
- Target height: 30 cm
- Desired ease: 0 %
- Stitch multiple: 1
- Row multiple: 1
- Rounding policy: Nearest valid count